Question 1

How much does riprap installation cost in Texas?

Accepted Answer

Riprap installation on the Texas Gulf Coast typically runs $50–$150 per linear foot depending on stone size, shoreline access, and the amount of grading required. Contact us for a free on-site estimate.

Question 2

What size stone is used for riprap?

Accepted Answer

Stone size depends on wave energy and water depth. Protected bay and canal locations typically use 12–24 inch stone. High-energy open bay and Gulf-facing locations require larger 24–48 inch stone. We specify the right size for your site.

Question 3

Does riprap require a permit in Texas?

Accepted Answer

Riprap installation below the ordinary high water mark in Texas typically requires permits from the Texas General Land Office (GLO). We coordinate permit requirements and can assist with the process.

Question 4

How long does riprap installation take?

Accepted Answer

A typical 100–200 linear foot residential riprap project takes 2–4 days including grading, fabric, and stone placement. Larger commercial projects are quoted on their own timeline.

Question 5

Is riprap better than a bulkhead or seawall?

Accepted Answer

For most residential waterfront properties on Galveston Bay and coastal canals, riprap offers the best long-term value — lower installation cost than concrete seawalls, minimal maintenance, and no corrosion. Bulkheads and seawalls make more sense where vertical structure is needed (boat docking, property line constraints).

Question 6

Can riprap be installed on an existing eroded shoreline?

Accepted Answer

Yes. Most riprap projects start with a badly eroded shoreline. We grade and reshape the bank first, install filter fabric to prevent soil loss through the stone, and then place the armor stone. The result is a stable, protected shoreline.

Riprap Installation — Texas Gulf Coast.

What we do.

Service area.

Common questions.